Quilting machine installation, dismantling, maintenance, after reading these, instantly enhance combat effectiveness.

Release Time:2018-07-26     Information Sources:Rongda     Browse:

Equipment repair is a normal thing, quilting machine is no exception. After using the computer quilting machine for a period of time, many parts of the equipment need to be maintained and repaired. Some parts may be aged and damaged due to improper operation and high load operation.

Moreover, the development of computer quilting industry in our country is also very fast, and the time of renewal of various parts of equipment is gradually shortened. Therefore, after using the computer quilting machine for a period of time, some parts need to be repaired, maintained and updated in time.

Quilting machine installation, dismantling, maintenance, after reading these, instantly enhance combat effectiveness.

When replacing parts of computerized quilting machine, professionals must be allowed to operate. If you have to replace it yourself, you need to pay attention to the following aspects:

1. When replacing, we must use professional tools, and must replace the parts that need to be replaced according to certain specifications. At the same time, we should pay attention to that the machine should be replaced in a relatively stable place.

2. When repairing or replacing the machine parts of the equipment, it must be approved by the equipment manufacturer or provided by them. Only when the model is the same, can the replacement test be carried out.

3. After replacing the parts of the computer quilting machine, the machine should be put into trial operation to ensure that there is no problem with the equipment before it is put into use. In the trial run, we should pay attention not to let hair, clothing, etc. come across pulleys and belts. We should take some protective measures first.

4, after the replacement of various components is completed, we must carefully check it. The main purpose of the inspection is to find out whether there is any contact problem between solder and other parts of the equipment, so that the insulation material on the circuit board is the same as before; check whether the screw nut is loose, it must be ensured that it is in a good tightening state.

5. In the process of replacement, if you want to open the electronic control box, you must first disconnect the power supply, and then after five minutes, you can operate, and keep your hands dry.


All Rights Rreserved © Shandong Gaomi Rongda Machinery Co., Ltd.