Release Time:2018-07-18 Information Sources:Rongda Browse:
The packing process of the baler consists of four steps: feeding, tightening, cutting and pasting.
The feeding process is rotated counterclockwise by the feeding pulley, and the frictional force between the toothed belt pulley and the packing belt is used to feed the packing belt forward along the packing belt until the end of the packing belt hits the micro switch of the belt stopping device. , so that the strap conveyor belt stops, in the position to be packed.
During the tightening of the strap, the belt is raised on the right pawl, and the belt pulley is rotated clockwise. The frictional force is also used to cause the strap to be withdrawn along the rail frame. At this time, the blade in the rail is retracted in the strap. Release under tension, the strap is continuously withdrawn until it is in close contact with the surface of the package, and the tensioning arm swings downwards to fully tighten the strap.
Next is the cutting process, the left claw rises two layers of packing tape to press, the isolation table exits and the hot head follows the follow-up, and the two ends of the packing belt are heated, which is the pressure block rising and cutting the packing belt.
After zui is the paste process. The hot head exits the actual position, and the pressure block continues to rise, and the two layers are pressed together by the heated packing tape to complete the packing action.